central locking interface

[leethomp]

does anyone out there no what wires get connected for the central locking using a sparkrite sr 911 interface.

thanks

[Graeme]

You need to swap the drivers door actuator to a five wire one and feed that a positve trigger or add a two wire one

[leethomp]

its already got a actuator in the door with two wires going to it as its the sr, so i still need anything else

[Graeme]

The factory set up only has a three wire switch and not an actuator, so will need swapping or adding to

[leethomp]

sorry for all the questions. i have seen a five wire universal one. do i remove the existing one i take it, also do i need one for the passenger door

thanks

[Graeme]

If it has the factory central locking set up you just need to swap the one in the drivers door, any five wire universal one should fit as long as it has the same mount screw spacings

[brainsnova]

What did that was not ideal was put a passenger solenoid in the driver side so it only worked with the fob and not with the key but a 5 wire one is a solenoid with the switch inside too so still works with the key