floor pans

[ratboy]

does anyone still make floor pans for novas????

just had to make some for my yank motor and it was a p i t a :mad:
so wondered if there is anyone that sells them?

[Iain]

I've never seen any floor pans for sale, you checked the Hadrians catalogue and German genuine panel stockists?

You could always drill the spotwelds off a good shell and use those

[bazil]

The forward section, ie from where your feet sit in the back to the bulkhead was never made as a replacement panel,

[abznovasport]

I looked but think i'm going to have to cut up an old shell. I couldnt even see where the spot welds are for the floor pan.

[ratboy]

bugger, oh well worth asking.
went to portugal and saw a few locals with novas battered but no rust and a couple of kids with slightly modded ones.
couldnt find any scrappys for rear lights or good panels but found one dumped in the middle of no where, wish i could have gotten it imported, no body damage and no rust at all.

[bazil]

The spot welds are on the underside along the sill