Parts £2 and under plus postage

[Cheeze]

Ok folk following on from my other post this is the little stuff that no one thinks about till they need them.

As the title all parts are £2 or under plus your postage, (£2 or under per item)

If they dont sell the lot will be going to the scrap

Any bit you need but cant see just drop me a pm

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010765.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010761.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010767.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010768.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010770.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010772.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010773.jpg

http://i157.photobucket.com/albums/t74/Cheeze1982/for%20sale/P1010775.jpg

:thumb:

[bigstevie]

could u keep for me two front hubs without backing plates, front antiroll bars and wishbones, antiroll bar tie brackets for front crossmember, gearlinkage, backing plates and sub axles. im going up to aberdeen in a couple weeks so will collect

[scott.parker]

Whats the linkage and lambda for mate?

Scott

[stevenf]

if thats a 2 pin oil pressure sensor in the bottom left of photo 7 i will have that off you :thumb:

[Cheeze]

Scott Linkage is nova one that i just took off my car, and the lamdba is a 5 wire universal one mate

StevenF Im sure it is a pressure sensor, but im also sure it was to small to fit in the oil pump, but just needs a adaptor i guess

[Phil_d]

Did you get my PM mate?

[General Baxter]

StevenF Im sure it is a pressure sensor, but im also sure it was to small to fit in the oil pump, but just needs a adaptor i guess

correct, its a auto gauges sender unit, 1/8" thread on it, i think the vauxhall one is 3/8"

[gary_126]

message sent, scrap the pressure sensor though, thought it was a 3/8 gm one

[Cheeze]

I will get back to everyone tomorrow requesting parts. Working away til tomorrow

[Lewis.]

Is that an ali oil filler cap in picture 1? (between the 2 starter motors and above the tie bar) if so put my name on it please :thumb:

[dan23]

do you have the splined part of the steering colum ( the bit the wheels fits on)

[Cheeze]

it would be a full steering coloum you would get dan

[Cheeze]

All parts bought will be posted tomorrow

[Lewis.]

Is that an ali oil filler cap in picture 1? (between the 2 starter motors and above the tie bar) if so put my name on it please :thumb:

How much for that oil filler cap posted mate?

[Cheeze]

Still a lot of bits here, last push before they get taken to the scrapy to be cashed in

[Peanut_119]

pm'ed

[kyl3_l]

Pm'd

[16v Nova Kev]

hubs with backing plates and rear drum covers?