where to wed in bung for wide band

[turbo-boy]

getting my exhaust made tomorrow for the gsi, im getting my bung welded in for the wide band i have read alot of different opinions on where to fit it as in how far from the turbo as if its to close to the turbo it say the sensor will burn out,looking for somone with one fitted to give me there opinion. i was going to weld mine about 5 inches from the turbo.

[Stuart]

9-12" from the turbo imho.

[Graeme]

All the ones I have seen fitted on lets have been down where the xe one would be between the back of the block and the bulkhead near where the drive saft passes over it

[Nick J]

I did quite a lot of research into this before my wideband kit was installed and ended up fitting at the front approximately level with the sump on the c20let. Many have different ideas but the people I trust said that was the best place for it.

Nick.