PDA

View Full Version : is there such a tool


swedge
22-09-11, 04:16 PM
right, trying to remove a driveshaft thats held on by a roll pin at the gearbox end

roll pin is ****ed and cant get it out as i cant get a good swing at it

i cant removed everything from the gearbox without dismantling the whole thing

is theres such a tool like a hub puller that will press out roll pins?

something that would clamp round the shaft and turn it with a ratchet to press it out?

ive ran out of ideas and cant get the fcker out
t45_ste
22-09-11, 04:50 PM
http://www.ultimatehandyman.co.uk/BOSCH%20ANGLE%20GRINDER.jpg
swedge
22-09-11, 04:54 PM
http://www.ultimatehandyman.co.uk/BOSCH%20ANGLE%20GRINDER.jpg


fail haha
scott.parker
22-09-11, 04:58 PM
http://www.ultimatehandyman.co.uk/BOSCH%20ANGLE%20GRINDER.jpg

using your noggin is not. lol
swedge
22-09-11, 05:12 PM
http://www.ultimatehandyman.co.uk/BOSCH%20ANGLE%20GRINDER.jpg

using your noggin is not. lol


doublew fail, try clicking the link
scott.parker
22-09-11, 05:15 PM
lol works fine, and now i see the pic in the topic too!
swedge
22-09-11, 05:16 PM
dosnt work for me just keep seeing that hotlink pic, im guessing its a grinder from the link name
t45_ste
22-09-11, 05:16 PM
http://www.retrobike.co.uk/forum/files/pag125n_125mm_angle_grinder_173.jpg

Not quite as funny now. lol
swedge
22-09-11, 05:18 PM
i would use a grinder but i need to keep everything apart from the cv
wwmnw
22-09-11, 05:21 PM
lol works fine, and now i see the pic in the topic too!

Ditto.
stevenf
22-09-11, 09:44 PM
if you can screw a self tapper into it then try to attatch a slide hammer to it. used this method before and it worked a treat
swedge
26-09-11, 10:57 AM
well still cant get the ****er out so its off to my mates with his welding torch to heat it up and get it out
Alex J
26-09-11, 11:47 AM
is this a renault by any chance??
swedge
26-09-11, 11:50 AM
is this a renault by any chance??

haha it sure is