View Full Version : changing from drums to disks ??
ryansnova
11-09-11, 07:55 PM
i went down to the scrapy and found a set 16s but that stick out past my arch on the back a bit so if i put disks on the back of the nova how much will it take the wheel in ? thanks :p
it won't take them in any further Ryan. The disk conversion still leaves you at roughly et49. Remember if you move the stub axles inwards the wheels and tyres are going to foul the inner arch. What wheels were they and what et? :)
ryansnova
11-09-11, 08:29 PM
the wheels are 16 by 7/5 and the ET is et35
the wheels are 16 by 7/5 and the ET is et35
7 and a half inches wide? and et35? they will never fit on a 3 door hatch.
ryansnova
11-09-11, 09:43 PM
yeah 7 and a half by 16s that fit nice on the front and only stick out on the back about 5-10mm
No way are they ET35 if they're only 10mm short of clearing. or do you mean they sit 10mm OUTSIDE the arch?
ryansnova
11-09-11, 11:23 PM
look i have been out and it says ET35 and when i put them on the car the wheel stuck out past the arch by about 7mm ruffly
MattBrown
11-09-11, 11:27 PM
Well don't moan on here about it.
Either buy them and mod the shell, or buy the right sized wheels.
7.5j is huge for a nova.
ryansnova
11-09-11, 11:40 PM
Well don't moan on here about it.
Either buy them and mod the shell, or buy the right sized wheels.
7.5j is huge for a nova.
who seid i was moaning?!!
and i already have got the wheels and btw what do you mean get the right sized wheels for a nova lol a speedlines not the right wheel for a nove but people put tham on novas lol
As in use the right offset for the arches you have :p
ET35 is stupid in all bar the widearch book.
Well don't moan on here about it.
Either buy them and mod the shell, or buy the right sized wheels.
7.5j is huge for a nova.
6j is plenty for a nova.
ryansnova
11-09-11, 11:47 PM
As in use the right offset for the arches you have :p
ET35 is stupid in all bar the widearch book.
but if i put a wide arch kit on it it would look stupid because the wheels will sit away in because the wheels with standerd arches stick out less than 10mm lol
look i have been out and it says ET35 and when i put them on the car the wheel stuck out past the arch by about 7mm ruffly
out of the arch by 7mm means they need to go in by about an inch, and at that point they will foul the inners.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.