View Full Version : Mk1 spoiler fitting
Just wondering what do most do when fitting a mk1 spoiler to a new boot just looking for opinions do I cut the bolts off and stick it on with tiger seal or drill mygood new boot and bolt on and just stick the sides :thumb:
drill it.. just measure it up well.... i fitted my predator in the field at the nats with a cordless
I'll give it a go I still have the old one so can prob measure off that one
Ever have any probs with rust afterwards
scott.parker
27-08-11, 11:34 AM
Treat the holes with some paint first then mate, and lots of sealer in around the holes etc.
well, you can paint up the bare metal & once dry, use sealant on the holes to make sure. the boot drains out at the bottom anyway, so it shouldn't be too much of a worry
I take that it's a bit pikey to just stick it in then I was at it today but a little nervous still bout drilling but I agree it would be the best option
even if you balls it up drilling you wont see fukkups
theres a guide in articles on the exact measurements anyway
Is there thanks andy I'll take a look and see
here y'are...http://www.pngclub.com/forum/showthread.php?94549-*HOW-TO*-Fit-a-GSi-spoiler
Exactly the same for mk1-theres no difference.
just use plenty of decent glue to fix the side bits.... i fitteda mk1 one years back & the glue failed when going up the mway& the spoiler was flapping round, i had to stop & tape it down..
That's a really good guide andy thanks wondered what way to measure it accurately haven't done it yet but will tomorrow thanks again
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.