PDA

View Full Version : fan broke



Dicko
07-07-03, 09:34 AM
ok turned fan on sat morning and it wont work

non of the speeds work at all. this is a MK2 style switch.

iv checked the fuse and its fine.

also iv noticed that the centre light doesnt come on when i pull the switch out for the rear window heater, and it worked b4 the fan stoped working?

chances are its the switch, or the wiring into the switch as this light doesnt worjk aswell?

frog_southampton
07-07-03, 10:14 AM
same as mine!

i got a portable one now plugs in2 ciggy lighter hole

dunno what wrong wiv my fans tho

AW3K
07-07-03, 10:53 AM
When mine didn't work it ended up being the Heater motor, Check the plug on the motor, check the resistor on the motor with a multimeter.


my lights didn't work cos all the bulbs had blown.

I got another switch from someone on ebay and that did the same.

The bulb runs off a seperate circuit, nowt to do with the switch (as far as i know). if you pull the switch out the chances are that the bulb holder will remain in the socket, If not it will be a grey plastic sleave with 2 pins on it. As the lights come on regardless of if the side lights are on etc.

AW3K

Dicko
07-07-03, 11:20 AM
yup, well the lights have had new bulbs and dont work :-/

will check the motor later but i got a feelijng its the switch, do you have a spare

hermmm silly me i have a spare mk2 nova on my driveway i can rob parts off that :D

Ste_Nova
07-07-03, 11:28 AM
failed black cap.... i bet the engine fan doesn't work either

Dicko
07-07-03, 11:31 AM
black cap? wheres that ill rob 1 off my TD :D

i will test engine fan later

hhmm just thinging, i might of checkjed fuse for engine fan not interior fan.

it was 3 along 2nd down on the fuse box. pic of a fan blade?

Ste_Nova
07-07-03, 11:39 AM
both fans are on a seperate feed from the black cap then 2 30amp fuses one for each

Dicko
07-07-03, 11:58 AM
ok so is the black cap behind fuse box?

Ste_Nova
07-07-03, 12:48 PM
at end of ignition barrel....


to test it join red to black... on will make ignition come on.... the other will make the fans come on

Dicko
07-07-03, 12:55 PM
cheers do i need to take barrel out of just the plastic cover?

Stuart
07-07-03, 01:38 PM
undo the two grub screws on either side of the barrel, it should come off then

frog_southampton
07-07-03, 11:15 PM
any more info on this coz my fan dont work either and i not very advanced wiv mota's :)

AW3K
08-07-03, 12:04 AM
A long shot but check fuses:

8 20.0 A Heated rear window
9 20.0 A Heater fan
14 10.0 A Right hand parking lamp, right hand tail
Licence plate lamp, *Instrument illumination*,
Egine compartment lamp, Headlamp warning buzzer


Like i say a long shot but you never know


AW3K

frog_southampton
08-07-03, 01:02 AM
yea i noticed tonight there no buzzer when open door wiv lights on and no lights on dash....

when put new fuse in it blew it straight away

AW3K
08-07-03, 11:53 AM
yea i noticed tonight there no buzzer when open door wiv lights on and no lights on dash....

when put new fuse in it blew it straight away

Another long shot but check behind the clocks/speedo to see if the loom has be rubbing on either the clocks or the chassis, mine did this and it removed the insulation off 2 live wires, therefor shorting it out.

Chack the contacts in the fuse box then trace the wires back looking for shorts like i said.

Hope it helps

AW3K

frog_southampton
09-07-03, 12:09 AM
any other ideas??

frog_southampton
09-07-03, 06:01 PM
come on!