Stuart
15-08-11, 10:07 AM
I have an old (I think I built it in 2005/6 lol) MSV3 with MSII processor here that I have zero use for etc.
It's built to take a VR crank input but I did fit as much Hall effect circuit as possible without stopping the VR from working.
I 'believe' there is the basic ignition circuit on the board but needs the additional drivers adding if you want to run wasted spark etc.
I will try to find all the case parts but at the moment there is the lower half and the LED end plate fitted.
Its been roughly tested a few years back so it will take a programming and also ran on the simulator board (might still have that so can chuck that in too).
I would honestly say its not a plug and play sale, you need to know a little about MS to complete the ECU imho.... It should be easy enough to do though.
Want about £200 for it, can post if necessary
Can get pics later.
It's built to take a VR crank input but I did fit as much Hall effect circuit as possible without stopping the VR from working.
I 'believe' there is the basic ignition circuit on the board but needs the additional drivers adding if you want to run wasted spark etc.
I will try to find all the case parts but at the moment there is the lower half and the LED end plate fitted.
Its been roughly tested a few years back so it will take a programming and also ran on the simulator board (might still have that so can chuck that in too).
I would honestly say its not a plug and play sale, you need to know a little about MS to complete the ECU imho.... It should be easy enough to do though.
Want about £200 for it, can post if necessary
Can get pics later.