View Full Version : Installing rear gsi anti roll bar
fastcar1cars
01-08-11, 06:41 PM
Hi all
How do you install a rear anti roll bar? Jus shove it through hole and bolt it in? Iv jus painted mine! Was that a bad idea?:roll:
mk1nova_rich
01-08-11, 07:19 PM
Pretty much, should slide in fairly easily but you need a bush in the middle of the ARB
just remember to jack up both sides & take a wheel off,
Yea as above push it thru the hole in the middle of the axle and bolt it up but as said there should be two bushes in the middle of the axle make sure you have these.
paul james
02-08-11, 09:56 AM
Yea as above push it thru the hole in the middle of the axle and bolt it up but as said there should be two bushes in the middle of the axle make sure you have these.
Two? Just having one bush on the ARB is standard I believe.
Two? Just having one bush on the ARB is standard I believe.
What I was thinking. Fitting 1 is a pain in the ass.
fastcar1cars
02-08-11, 06:01 PM
Mine came with two!
Yes you'll lose some paint in the process of fitting, try opening the holes up either side a bit to minimise the paint loss!
[QUOTE=Tim;1908103]What I was thinking. Fitting 1 is a pain in the ass.[/QUOTE
Yea mine has two guys.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.