View Full Version : Skirt mounting holes...
Hi
i was looking at my arches and noticed the dimples in the metal, i have a set of skirts and i placed them over the dimples and it looks like it lines up.
http://www.a-whiteman.pwp.blueyonder.co.uk/car/arch2.jpg
Can someone confirm this as i don't want to be drilling a 6mm hole into it if it aint right.
Cheers
AW3K
get that rust reapaired first m8, will only get worse when the skrts r on :?
get that rust reapaired first m8, will only get worse when the skrts r on :?
As if by magic
http://www.a-whiteman.pwp.blueyonder.co.uk/car/car1.jpg
AW3K :D :D :D :D
Nova-Boy
06-07-03, 12:56 AM
Has that been done properly or on photoshop or something??
Looks much better
Has that been done properly or on photoshop or something??
Looks much better
I did that over many hours/ days
http://www.a-whiteman.pwp.blueyonder.co.uk/car/car2.jpg
Nova-Boy
06-07-03, 01:04 AM
Good work. I'm doing the same with my arches at the same point. and my boot and etc etc etc.
Good work. I'm doing the same with my arches at the same point. and my boot and etc etc etc.
thank you
Gotta do some on the sill and the door b4 i can fit the skirts
project over the summer if it stops raining that is
thesparky
06-07-03, 10:57 AM
the dimples are spot welds the skirts are easy to fit i did sum so they must be!
Nova-Boy
06-07-03, 11:18 AM
I dont like the idea of drilling holes in my boot for my spoiler or down the side for the side skirts. I think its more likely to go rusty if you start drilling holes. Even if you paint them etc etc.
U can place silicone over the rivets 2 help protect it from rust also! It will seal up the hole from letting water thru 2!
greg00uk
06-07-03, 12:04 PM
good job on the sraying, but the paint still has rust underneath it, you can see it. did you sand down with electric sander? :(
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.