Couple of wheel fitment and pannel questions...

[Calamity Josh]

Firstly, i've been looking at what i'm going to do on my '85 2dr loon and the wings have some rust, nothing major and i was thinking of just getting new wings, but i can't find them without the side repeater like the ones that were on it, any ideas?

Secondly i've been looking at getting some brand new wellers for it...
i have the choice between:



"This style of 7x13 is available in black and the following PCD's and offsets :

4x100
4x108

ET = Pos15
ET = Pos03"



"The 8x13 is available in black and the following PCD's and Offsets

4-108
4-100

ET = POS15
ET = NEG10
ET = NEG59"




"The 10x13 is available in the following PCD's and Offsets

4-108
4-100
ET = NEG32
ET = POS18"


which would give the best look for a sort of retro/euro style and what would fit and if not what work would be needed? thanks in advance, any help majorly appreciated!

[marc69]

Your wings...

if you know a welder, get him to put a wee patch behind the repeated hole then fill with good filler, ensure you use good primer on both sides before painting to ensure the filler never "grows" i.e gets moisture in it.

If you can't get a patch wleded, use fibreglass, back to bare metal round where you put it, once it is dry then go to the filler etc.....

[Connor]

txt ya