1.4 mpi sri engine clutch and flywheel

[JordyzNova]

im picking up a corsa sri engine for my nova today and its got no fly wheel or clutch do i have to use a mpi engine flywheel and clutch or could i just use a 1.2 8v corsa one :confused:

thanks :thumb:

[Steve0011]

the mpi i have came from an astra (i think) and had no flywheel, the flywheel from the 1.4 spi i had was about an inch too small. lucky for me i had a spare engine (mpi) and it had a flywheel.

the clutch from the single point engine was fine.

[Adam25]

Youll need the larger type to suit the f13 box, but as said the clutches are the same, some 1.4s do use the smaller flywheel but the mpi uses the larger one.

[JordyzNova]

Youll need the larger type to suit the f13 box, but as said the clutches are the same, some 1.4s do use the smaller flywheel but the mpi uses the larger one.


im lookin to use just a 1.2 8v corsa box as i heard they have good ratios . . . .
i need a mpi flywheel then
and i can use the spi clutch
:thumb:

[mk1nova_rich]

the MPi engines have a larger flywheel which means the starter is moved further out, so a smaller flywheel cannot be fitted. The clutch should be fine if it bolts to the flywheel ok

[JordyzNova]

the MPi engines have a larger flywheel which means the starter is moved further out, so a smaller flywheel cannot be fitted. The clutch should be fine if it bolts to the flywheel ok


right does it have to be 8v ? beacuse ive scorced a fly wheel clucth of a corsa gsi engine 1.6 16v ecotec and a gearbox off a 1.6 16v tirgra

any suggestions are welcome :tard:

[mk1nova_rich]

pretty sure they fit ok but I would wait for confirmation :thumb:

[Nobby]

but a 1.0 gearbox wont fit will it?

[JordyzNova]

ive got clucth fly wheel and box off bakers gsi lump (y)