View Full Version : Ignition/Starter Switch Panel
calibra-keith
02-07-11, 05:17 PM
Hi, im sure this is an easy one to most people, wiring is my weakest point
what wires go to were ? also its for track car so not sure if makes a difference with the old ignition positions ?
http://i236.photobucket.com/albums/ff269/calibra-keith/Picture292.jpg
http://i236.photobucket.com/albums/ff269/calibra-keith/Picture293.jpg
thank you
It's all explained in the Haynes Max Power book ;). I'll try and get some pics.
Not entierly sure with a track car but on my car i took the black/red wire from the back of the ignition switch put it to a terminal on the left hand switch, put a wire from one switch to the other and then put a permanent live to the remaining terminal, so the push button will only work when the toggle is switched, as for the ignition i took the glove box out and traced the red and black wires from the ignition switch and spliced into them and put it onto an isolator key in the glove box, but you could take the red and black wires put them to the toggle and then the black/red started wire and put it to the push button and then a permanent live to the other and use it for ignition and starter, hope this helps :)
http://i1085.photobucket.com/albums/j438/phildgsxr/DSC00243.jpg
calibra-keith
02-07-11, 11:45 PM
It's all explained in the Haynes Max Power book ;). I'll try and get some pics.
not got it, infact iv only ever got a max power mag once a very long time ago lol
Not entierly sure with a track car but on my car i took the black/red wire from the back of the ignition switch put it to a terminal on the left hand switch, put a wire from one switch to the other and then put a permanent live to the remaining terminal, so the push button will only work when the toggle is switched, as for the ignition i took the glove box out and traced the red and black wires from the ignition switch and spliced into them and put it onto an isolator key in the glove box, but you could take the red and black wires put them to the toggle and then the black/red started wire and put it to the push button and then a permanent live to the other and use it for ignition and starter, hope this helps :)
i did have a go and put red/black and red from starter motor for push start before i posted (turned over) but best i ask first as there is like 3 blacks, one red on its own, red/black and another red i guess some are for the different ign positions i just need ign on/off and push start (and red light i suppose)
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.