im a tit lol

[pikey1986]

after finally getting some motivation to crack on with my nova i realised that i never bent the clutch cable lug on the bulkhead:tard:

is their any easy way to bend this without damaging it or can i just hacksaw it off if its not needed?

[nova_stee]

Dont bother mines been fine and so have all the others ive done

[General Baxter]

i done that, then ended up getting recovered lol

its still needed to get the correct pedel feel and lenght,

i took the inlet off and bent it :)

[comptoncj]

As baxter says i think the inlet needs to come off to get in there to bend it. I had to do mine twice as the first time i didnt do it enough and the cable snapped lol

[pikey1986]

damn! was hoping id not need it, cheers baxter + compton

[Mazz]

Drop the engine off the front 2 mount and lower down on a jack, then ram a 1/2" extension in there and bend away :)

It needs to be bent in a 4:00/5:00 direction

[nova_saloon]

never knew it had to be bent, i never touched mine and mines always been okayish, well i think its okay, best change that when the engine comes out for the gearbox swap. anyone got any pictures of theres when this is done, i just thought it was the matrix pipe that needed doing

[General Baxter]

it needs to be bent, as the clutch cable will rub on the back of the inlet,
and the 90degree angle it comes out of, is not good,
you bend it to reduce the angle, and to miss the inlet