*HOW TO* c20xe R1 bike carbs

[jonn]

i thought this information might be useful for anyone thinking about fitting bike carbs.
>http://www.totalvauxhall.co.uk/files/2010/10/64BIKECARBS1.pdf<

megajolt setup
http://trigger-wheels.com/store/contents/en-uk/d34.html

http://www.autosportlabs.net/Main_Page
here is some pictures and information for R1 carbs that i put onto my c20xe

this is what the carbs look like the fuel inlet is in the middle underneath the carbs.

http://i421.photobucket.com/albums/pp297/jonny057/Picture039.jpg

the best fuel pump to use is the r1 pump, it has a built in regulator. when you are wiring in the pump
make sure you dont mix up the wires because the pump will burn out! the earth is the black wire.

http://i421.photobucket.com/albums/pp297/jonny057/Picture038.jpg

you will need to get a manifold made, these can be got off boggs brothers, i made my own manifold

http://i421.photobucket.com/albums/pp297/jonny057/122.jpg

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0795.jpg

you will need a altanator adjusting bracket, i made my own one

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0799.jpg

the main jets need to be drilled out to 1.8mm for a c20xe these are the middle jets.

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0804.jpg

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0814.jpg

for the ignition set up you can use a mk2 cavalier ignition set up or megajolt setup which is what i used.

http://i421.photobucket.com/albums/pp297/jonny057/Picture026-1.jpg
wiring diagram
http://i421.photobucket.com/albums/pp297/jonny057/ChevetteWiring1-1.jpg

if you use megajolt you will have to move the new coil up so the plug leads will reach. i modified the old one

http://i421.photobucket.com/albums/pp297/jonny057/Picture033-1.jpg

to connect the carbs to the manifold i used 42mm water pipe and jubliee clips

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0793.jpg

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0792.jpg

all fitted

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0794.jpg

http://i421.photobucket.com/albums/pp297/jonny057/SAM_0799.jpg

[16v Nova Kev]

nice guide wish i hadn't sold my set.

[autoworksnovasport]

what did you do with the water way???

[jonn]

i just blanked off the water ways, the manifold and carbs never really get warm so it still runs fine

[pandy]

whats the reason youve linked each port on the manifold is this a must cheerz :)

[mk1nova_rich]

just to add - fuel resistant hose might be an idea for the long term ;)

[gteben]

NICE WORK i have one question as im new really to playing with engines. can i fit this to the e16se engine ???

[saloon-mogz]

yes

[davidfox280585]

may i add, a cheaper way to spark zetecs would be the e.s.c module from early fiesta 1.1 a this is similar to ford edis. vauxhall probally read off a different number but if they dont then its a cheap way