View Full Version : Engine stand bolts...
Nova_Tek
19-05-11, 02:55 PM
Just realised that the bolts that fix the gearbox to the block are too short to go through the engine stand arms into the block.
Anyone know what size the standard bolts are? Gonna see if I can find a few that are the same size but longer.
Thanks :thumb:
i use either m10 or m12 stud bar with nust either end, does the job lovely
i use either m10 or m12 stud bar with nust either end, does the job lovely
2nd that.
Nova_Tek
19-05-11, 04:10 PM
cheers lads
The bolts that hold the rear mount to the gearbox are the right length:thumb:
I used m12 ones just went and got them from a hardware store were spot on!
Danb1987
19-05-11, 10:35 PM
I had to make some aswell lol I found out that they didn't fit on tuesday..... I was like... WTF lol
Nova_Tek
20-05-11, 12:10 AM
Will be going to a hardware store tomorrow to get some. I was like 'WTF' too lol
am i the only pikey cause i welded some odds and sods together to make them fit lol
Nova_Tek
20-05-11, 12:13 AM
^ Yes... yes you are! lol
thedondy
20-05-11, 01:04 PM
old head bolts are what i use, m12 if i mine right
Nova_Tek
20-05-11, 08:06 PM
Cheers lads all sorted now, purchased a couple M12 hex bolts and some nuts too. Used them together with the gearbox bolts. Worked a treat!
:thumb:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.