Engine stand bolts...

[Nova_Tek]

Just realised that the bolts that fix the gearbox to the block are too short to go through the engine stand arms into the block.

Anyone know what size the standard bolts are? Gonna see if I can find a few that are the same size but longer.

Thanks :thumb:

[Fow16v]

i use either m10 or m12 stud bar with nust either end, does the job lovely

[bmw156]

i use either m10 or m12 stud bar with nust either end, does the job lovely

2nd that.

[Nova_Tek]

cheers lads

[Adam25]

The bolts that hold the rear mount to the gearbox are the right length:thumb:

[honie5]

I used m12 ones just went and got them from a hardware store were spot on!

[Danb1987]

I had to make some aswell lol I found out that they didn't fit on tuesday..... I was like... WTF lol

[Nova_Tek]

Will be going to a hardware store tomorrow to get some. I was like 'WTF' too lol

[Paul]

am i the only pikey cause i welded some odds and sods together to make them fit lol

[Nova_Tek]

^ Yes... yes you are! lol

[thedondy]

old head bolts are what i use, m12 if i mine right

[Nova_Tek]

Cheers lads all sorted now, purchased a couple M12 hex bolts and some nuts too. Used them together with the gearbox bolts. Worked a treat!

:thumb: