View Full Version : Temp gauge not working
I tried a new sensor, new wire from the sensor to the clocks and just tried earthing the wire straight to the block but the needle didn't move at all. Any ideas please? :confused:
Royston
18-05-11, 05:28 PM
Gauge goosed
Gauge goosed
Exactly what I was thinking :( Is it possible for me to get a new gauge for the clocks?
Royston
18-05-11, 05:47 PM
Would think 2nd hand, but probably another set of clocks, got a base model set off the D plate saloon I'm breaking
Would think 2nd hand, but probably another set of clocks, got a base model set off the D plate saloon I'm breaking
I'm using a set of sport clocks so I don't want to give up on them just yet.
Novasport
18-05-11, 06:04 PM
Have you checked the printed circuit board on the back as they often get damaged or break.
breadstraw
18-05-11, 06:27 PM
my dials did this quite often
sometimes it would work though
and then my petrol guage would stop working
i never figured out what caused it
but a good hard punch straight in the centre of the temp and petrol guage usually sorted my issue out ;)
Have you checked the printed circuit board on the back as they often get damaged or break.
I repaired the circuit board being as there was a break at the bottom. Changed the temp dial for another out of another set of clocks I had laying around and its still not working :mad: lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.