PDA

View Full Version : xe/let/v6 loom hole size for loom bung?


Nobby
15-05-11, 08:59 PM
as above on the bulkhead to get the ecu inside what size do you cut them to?
Andy
15-05-11, 09:12 PM
if its the same as an xe/let iirc its 67 mm
Im sure it is,although dont commit till someone else posts the same lol
Jack
15-05-11, 10:03 PM
I don't think we enlarged the hole on mine (originally we had an XE in there) but we did make a small extra chunk on the top to allow us to squeeze the ECU plug through. Pretty sure that was for the V6 setup we did that...
Lee H
15-05-11, 10:08 PM
52mm rings a bell here for some reason.
NOVA saloon
16-05-11, 01:21 AM
52 mm look in articles will tell you there.
nova_stee
16-05-11, 08:11 PM
Yeah 52mm hole saw if you use one for wood buy ten lol
Gareth_C
17-05-11, 10:21 AM
2"/52mm
Nobby
17-05-11, 10:58 PM
boo ive got a 54mm
Ben
18-05-11, 07:02 PM
54mm will be fine, 2mm is easily covered with a bung.