View Full Version : xe/let/v6 loom hole size for loom bung?
as above on the bulkhead to get the ecu inside what size do you cut them to?
if its the same as an xe/let iirc its 67 mm
Im sure it is,although dont commit till someone else posts the same lol
I don't think we enlarged the hole on mine (originally we had an XE in there) but we did make a small extra chunk on the top to allow us to squeeze the ECU plug through. Pretty sure that was for the V6 setup we did that...
52mm rings a bell here for some reason.
NOVA saloon
16-05-11, 01:21 AM
52 mm look in articles will tell you there.
nova_stee
16-05-11, 08:11 PM
Yeah 52mm hole saw if you use one for wood buy ten lol
Gareth_C
17-05-11, 10:21 AM
2"/52mm
54mm will be fine, 2mm is easily covered with a bung.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.