View Full Version : Brake servo studs
garethcolley
02-05-11, 07:12 PM
Hi,
Can the brake servo studs be removed or are they welded or fixed from the other side (inside the servo) during assembly? I would like to remove them and fit longer ones if possible.
Thanks in advance.
Gareth
you mean the studs on the metal square that the servo sits on?
i think they are fixed but they may come out if you try hard enough
you could drill them out run a tap through the hole an insert new longer studs
why do you want to run longer studs ?
garethcolley
03-05-11, 10:19 PM
you mean the studs on the metal square that the servo sits on?
i think they are fixed but they may come out if you try hard enough
you could drill them out run a tap through the hole an insert new longer studs
why do you want to run longer studs ?
Hi Dan, thanks for the reply. I mean the studs that are part of the servo that you bolt to the servo bracket. I need to put some longer ones as i'm fitting a cav turbo servo to my nova which will need spacing off the bracket by about 40mm hence the standard servo studs not reaching.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.