View Full Version : Converting to 5 stud on small block?
clubberlang23
26-04-11, 08:11 PM
I know its probabaly been asked 100 times before, but i can't really find to much info on it. What parts/bearing are needed and what maching is needed (I am manual miller by trade so not a problem, also have a spare set of front hub knuckles)
clubberlang23
26-04-11, 09:48 PM
Any1 give me some info?
MattBrown
26-04-11, 09:53 PM
Streight up it can't be done. (bolted together)
But if it's a smallblock, I'd cut n shut the shafts.
If you staggered cut them, and sleeve them, then balance them I can't see an issue?
Unless it's some 220bhp c16xe?
mk1nova_rich
26-04-11, 09:58 PM
Streight up it can't be done. (bolted together)
But if it's a smallblock, I'd cut n shut the shafts.
If you staggered cut them, and sleeve them, then balance them I can't see an issue?
Unless it's some 220bhp c16xe?
cut and shut shafts?! :wtf: you use Mk4 Astra stuff IIRC
You can get adapters but they're no cheap
Are you thinking of fitting 5x110 wheels?
F13box to Astra mk4 1.8 inner cv to big block conversion shafts to cav/cally 5 stud hubs machined to fit nova bearings,
Inner cv pattern part number from AMK TDL4950
shed-on-wheels
26-04-11, 11:19 PM
or use cav mk2 outer c.vs on gte/gsi shafts
MattBrown
27-04-11, 12:51 AM
cut and shut shafts?! :wtf: you use Mk4 Astra stuff IIRC
Yup, I have seen worse (Welded up cvs together) etc.
Sure a member on here welded part of an inner to part of an outer in some real bodgerylol
There's no problem with modifying shafts, intact, there's companies out there who do this as a business. But ultimately, Bazil is 100% correct"
Just a note on pcd adaptors, iirc they are about a minimum width of around 16mm so a et49 wheel becomes et33 and difficult to fit on a nova,
However these adaptors are readily avalible on eBay and some of the companies will make to order at no extra cost.
clubberlang23
27-04-11, 08:25 PM
Cheers for the advice, so many options! Think i'm gonna go down the route of gte/gsi shafts with mk2 cav cv's. Now i need to make a parts list so i can post a wanted thread up.
Am i right in thinking i'll need (please add or correct parts)
GTE/GSI shafts
Mk2 cav cv's
Cav v6 front and rear hubs & brakes
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.