View Full Version : Snapped temp sensor in inlet manifold
Vausey_Nova_Knotla
21-04-11, 01:50 PM
can i have some options on how to remove this?
get a stud extractor kit or at a push try knocking an allen key gently in....
drilling will put loads of swarf into the cooling jacket... not good for water pumps & radiators...
is it flush? can you get a cold chisel onto it?
drill the middle? should be easy if its brass.
and what are those opposite bolt thread things called. easy outs?
GRUNT 16V
21-04-11, 01:54 PM
add some heat if you can !!!!!
Vausey_Nova_Knotla
21-04-11, 02:00 PM
Nope its slightly in so manifold sits higher.
http://cgi.ebay.co.uk/5PCE-DAMAGED-BOLT-SCREW-STUD-EXTRACTOR-REMOVER-EASY-OUT_W0QQitemZ130324194699QQcmdZViewItem?rvr_id=226 524532080&rvr_id=226524532080&cguid=dcc8b00112e0a0aa17338303ff634417
Vausey_Nova_Knotla
21-04-11, 03:34 PM
Ta :)
nova_saloon
21-04-11, 03:36 PM
drill it out if none of the above work. but id take the manifold off to do this if the extractor doesnt work. so you can clean the filings properly. try not to ruin the thread if you do either helicoil. or just weld it up and drill a hole next to it and tap that a new one!
can you braze \ silver solder a nut on and wind it out?
i snapped a sender ages back. they are so weak that soldering would just make a horrid mess. they are soft as anything, the stud extractor is the kiddy for the job
Southie
21-04-11, 07:41 PM
Get some pictures up to show how bad it really is.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.