Iain
16-04-11, 01:57 PM
22 spline shafts, standard brand new outers and "big block" conversion inner CVs.
I can rotate the wheel which in turn immediately rotates the shaft, but there's a few mm of play before the inner CV joint actually moves. So I can wiggle it back and forth and not move the inner CV/diff.
Is this OK for an inner CV or should I be looking to replace them?
I can rotate the wheel which in turn immediately rotates the shaft, but there's a few mm of play before the inner CV joint actually moves. So I can wiggle it back and forth and not move the inner CV/diff.
Is this OK for an inner CV or should I be looking to replace them?