Meriva Discs- what spiggot rings

[Paul]

280mm discs, they need a very small spiggot ring, is it a job for an engineer or is there an off the shelf item?

[Adam]

Run them without.
I dont use spigots

[Mike]

I use these discs with no spiggots at all Paul, Ive got dowled hubs tho so they hold the disc in place.

[maddogdaz666]

is that safe, as ive got a meriva brake setup as i didnt like re-drilling a 5 stud disk as i dont think its too safe,

[Tony M]

When fitting the Meriva discs you put the screw that holds the disc to the hub at the top so its all even.

[maddogdaz666]

gotta be stronger than drilling more holes :)

[Adam]

I have no spigots and no retaining screw in my disks.There only purpose is to keep the disc aligned when you are trying get the wheel bolts back in

[novacabrio]

Paul's sport is running them with no spiggot ring. Locating screw lines up so you should be ok

[Mieran]

I had these on my corsa with mtech conversion hubs, gap was big tbh but I never ended up getting spigot rings

[Paul]

I will be using spiggot rings.