PDA

View Full Version : Oil pressure



swedge
10-04-11, 11:28 AM
Where would the sensor be on my c14se

comptoncj
10-04-11, 11:31 AM
on the side of the oil pump iirc, as you look at the engine in the car its on the back.

swedge
10-04-11, 11:33 AM
Also how does the light work on the digi dash I can't see an oil icon at the bottom just the gauge bit at the top

swedge
10-04-11, 11:34 AM
on the side of the oil pump iirc, as you look at the engine in the car its on the back.


Hmm I have nothing plugged in there and no spare plugs on my main loom

brainsnova
10-04-11, 11:42 AM
The square round the pressure symbol is the low oil light and the bars are the pressure :d

swedge
10-04-11, 11:57 AM
Should the plug be part of the main wiring loom?

swedge
10-04-11, 12:07 PM
Just checking how my digi dash is wired up and there are 2 blue and green wires on the car side and only 1 on the black digi dash plug

How do I know which one to wire in?

swedge
10-04-11, 12:09 PM
Ones a light blur

swedge
10-04-11, 12:10 PM
Ones a light blue ones a dark blue

swedge
10-04-11, 01:19 PM
just going over my wiring again and i have a thin blue/red wire coming from the small plug on my ecu thats not connected to anything

any ideas

Iain
10-04-11, 07:36 PM
Oil warning light should be blue/green, and it should be on the main Nova wiring loom. If you can't find one it should be easy enough to add one from the blue/green of the digidash to the pin on the oil pressure sender.

swedge
11-04-11, 06:28 AM
Could someone check thier Haynes manual and see what the red and blue wire from the small ecu plug is for pretty please :)

I think I've found it but on the diagram it just goes down the bottom where the track numbers are and didn't show what it's for