Weber DMTL adapter plates

[mk1nova_rich]

I have both adapter plates for mounting a Weber 34/32 twin choke carb to a 1.3/1.4 SR inlet manifold.

I bought this a couple of weeks back from garyc but managed to source a complete setup just afterwards so this is now surplus to requirements. Unfortunately a small section of the air filter adapter casting has broken off...but the broken piece is still present and intact so could be repaired quite easily.

Looking for £15 posted which is less than what I paid for it, no offers!

Please PM or leave your email address below if you would like a picture, many thanks :thumb:

[John]

Rich i meant to ask, is there 2 parts to it? I'm sure one bit bolts straight on the manifold, then the other is the adapter for the carb? Ta :)

[mk1nova_rich]

One part bolts onto the manifold, then the carb sits on that, then the other part sits on top of the carb so the original air filter can be used AFAIK - I can take a pic of the complete setup I have tomorrow so you get the idea?? :)

[John]

Just checked your pic again, i'll take it. Pm me your details. :)

[mk1nova_rich]

PM'd

NOW SOLD!