first time fitting

[swedge]

a sill :)

ran out of welding wire though so will have to finish this side tomorrow

the welds are solid on the bottom as it got the hammer test lol

just go the tops to finish then do the other side lol

http://i228.photobucket.com/albums/ee127/swedge87/IMG_0064.jpg
http://i228.photobucket.com/albums/ee127/swedge87/IMG_0063.jpg
http://i228.photobucket.com/albums/ee127/swedge87/IMG_0062.jpg

ignore the door lol i have a replacement

[philly]

Did you use a full sill or just a sill skin?

[G-nova]

good on you mate gotta start somewhere, wish I could weld

[Nobby]

Ive seen worse lol well done for having ago ive jus done mine +rep

[swedge]

Did you use a full sill or just a sill skin?

it was a full sill but i only used half of it

was only the underneath that was ****ed

[swedge]

good on you mate gotta start somewhere, wish I could weld

im not the best welder either, i bought a welder from someone on here i think for about £40 its gassless though and ive been told the one that uses gas is better as it runs cooler or something

[16v Nova Kev]

well done for having a go but mig welding with gas is much better.

[swedge]

well done for having a go but mig welding with gas is much better.

yeah ive been told that

once my cvars done i might invest in a gas one and sell this one

[swedge]

im amazed no1 has spotted my nice clean engine in the background :)

[wwmnw]

I read the thread title as "First time fisting" :(lol

Canny job you've done, nice clean engine in the back ground, lol

[calibra-keith]

i was pretty poor when using cheap gasless welder (90's and 110's) did the job i needed at the time but a decent welder with gas makes a load of difference im on the look out for a newer decent welder at moment i need to do fair bit of welding inc sills.

[swedge]

I read the thread title as "First time fisting" :(lol

Canny job you've done, nice clean engine in the back ground, lol

im a pro at the fisting now lol

at somepoint there been a dent in fron of the rear arch, musta been pushed in 1-2 inches and instead of pulling it out it been fiberglassed and filled

i was choking with the dust coming of it grinding away "hoping" for some metal behind it all lol

[brainsnova]

I noticed your engine but had to zoom in on my phone to see what it was.

[General Baxter]

loving the axle stand bolt,

baxtering at its best lol

[swedge]

loving the axle stand bolt,

baxtering at its best lol

Lol that's my "bashing hitting chipping" screwdriver I always use it lol lost the bolt ages ago