View Full Version : xe manifold to nova stainless system
I was just wondering what people do to mate the manifold with your existing system. I have apowerflow stainless system for an xe nova. And i belive the manifold is an early typefrom an astra. Any pixs would be much aopreciated.
Tim
Cut, pipe/flexi, weld.
any pics???
Pistol Pete
23-02-11, 08:34 PM
I have some in my rebuild thread. Will get some.
http://img.photobucket.com/albums/v310/Pete_58/Nova/IMGP2604.jpg
http://img.photobucket.com/albums/v310/Pete_58/Nova/IMGP2605.jpg
http://img.photobucket.com/albums/v310/Pete_58/Nova/IMGP2607.jpg
Took a while to get right. Basically cut sections from the pieces i removed.
I then ground all the welds back, "pressure" tested it, filed in any pin holes, BBQ paint and heat wrap tape. Job jobbed. More pics in my rebuild thread (link in my sig)
Bit of a tight bend there!
Mine is just cut off, and a flexi fitted between it and the exhaust system
Pistol Pete
24-02-11, 05:47 PM
No tighter than the primaries that exit from the head!
And when all said and done, it fits and does the job!
thanks for the pic. it gives me an idea what i need to do.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.