what to do when fitting a 1.6

[Vausey_Nova_Knotla]

Hi all what is needed to be done to fit a 1.6 gte engine into a nova thats had a 1.2. Wiring.. so on.. also are all the nova engines clutches same? and will a 1.4 flywheel fit a 1.6 engine thanks rob.:thumb:

Also my dizzy capisnt like the round one its a square one?

[Connor]

Was the 1.2 carbed?

[MattBrown]

3 wires and it will run.

Easiest conversion probably!

Either a mpi tank with mpi pump, sip tank and mpi pump or gte/gsi tank with mpi external pump.

:)

[Vausey_Nova_Knotla]

yes it was carbed. So do i need a new tank? or just a fuel pump? and whats needed to fit a flywheel and a clutch? thanks rob

[mk1nova_rich]

You will need the flywheel, clutch and starter motor from the 1.6 and also an F13 gearbox. Your current driveshafts will be fine though

[Damo]

Do a search mate been covered hundreds of times.

[Vausey_Nova_Knotla]

Do a search mate been covered hundreds of times.

ive searched and cant seem to find anything? the search tool is ****e tbh or my searching method...

[mk1nova_rich]

give us a text if you want a hand with the swap :thumb:

[Rickyb]

http://www.pngclub.com/forum/showthread.php?t=112394&highlight=e16se+engine+fitting+guide
hope this helps :thumb:

[Andy]

You CAN keep your original tank and just run an external pump.
Just dont go under quarter of a tank and drive hard round corners thats all.

[bazil]

3 wires and it will run.

Easiest conversion probably!

Either a mpi tank with mpi pump, sip tank and mpi pump or gte/gsi tank with mpi external pump.

:)
pump it up (http://www.youtube.com/watch?v=1K7fL5s_1ac)

what matt said fuel delivery is key

[Vausey_Nova_Knotla]

You CAN keep your original tank and just run an external pump.
Just dont go under quarter of a tank and drive hard round corners thats all.

cheeers for that mate, is there not another way to get round the not going under quater of a tank but still use old tank because my tank fuel guage is ****? and also what fuel pump is needed