Throttle linkage

[Matty Winslade]

I just got a new TWIN CABLE mangoletsi throttle linkage to use with my new twin dellorto's !! I wad just wondering ...when I attach the new pedal block to the pedal stem , I'll obviously have to Feed to cables throgh the bulk head !! one will be there from the original but will I have to drill the other one ?
Thanks in advance
Matt

[SR-Rally]

You'll have to plate the old one and drill two 5-6mmish holes to the left and slightly lower then the original hole. Cut down pedal and fit the block to it. You will then be able to see/mark where you need to drill new holes. :) if you get stuck give me a ring.

[Matty Winslade]

Thanks ben :) yeah you should see the carbs mate, they look laaavley ....going into work to fit them in the morning . the thottle set up i beleive is going to be the hardest part :confused: so its a case of drilling two holes ?
then i suppose putting gromets in and clmping the pedal block onto the shaft??
thanks mate :)