punto clutch or not ??

[bally2010]

was out in car with my mum ,when she put her clutch in it made a very rough and loud clunking noise and wouldnt select a gear . so turned off engine had a check to see if i could see what it was no joy there so started it again just started to put clutch in and again the noise came and a horrible smell from under the bonnet smelt of burning there was only 10 miles left to get the car home so just got her to drive it home without using clutch , any ideas ??

[BRoadGhost]

Find a new mum

[Connor]

Find a new mum
lol lol lol lol lol +rep

[db_1.2]

Thrust bearings pushed through, new clutch assembly

[bally2010]

Find a new mum

funny you im all good with the one i got at moment thanks

[Will F]

Find a new mum

lol Awesome.

Does sound the the release bearing has collapsed..

[bally2010]

well if i put clutch in it constantly makes the noise when i let it out sounds normal and when driving is fine until i touch clutch pedal

[davidfox280585]

Thrust bearings pushed through, new clutch assembly
http://www.forumsextreme.com/images/sSig_iagree.gif
http://www.forumsextreme.com/images/sSW_saberfight2.gif

[Dervy]

Find a new mum

+rep for that well funnylol lol lol yea i would say release bearing, they are crapy plastic ones

[Asa-James]

Yup, replace clutch and release bearing. If it's a 1.2 then it's a doddle, less than 2 hours (I've seen it done in 45 mins)

[db_1.2]

Yup, replace clutch and release bearing. If it's a 1.2 then it's a doddle, less than 2 hours (I've seen it done in 45 mins)

Yeh it's a piece a pish. Done one on a bravo, with the same engine, and the same problem