mark69
07-02-11, 08:23 PM
what have people done witht he water pipe that goes into the inlet when using bike carbs?
i made my own manifold but were the water runs on a standard inlet, ive blocked off and put the water temp sensor there.
the 2 pipes from the matrix just go into the same pipe that runs under the inlet.
its running too hot and the matrix/heaters arnt getting warm..
any tips/pictures of how others have got around this problem?
or am i just doing somthing wrong...
i made my own manifold but were the water runs on a standard inlet, ive blocked off and put the water temp sensor there.
the 2 pipes from the matrix just go into the same pipe that runs under the inlet.
its running too hot and the matrix/heaters arnt getting warm..
any tips/pictures of how others have got around this problem?
or am i just doing somthing wrong...