Carbon Fibre sheet x2

[Mike]

Both approx 200x240mm

Double layer carbon fibre with a nomimal thickness of approx 1.2mm, 2x2 twill @ 200g/m2. For some reason both have ripples in them (possible over zealous curing temp :confused: )

£SOLD.
-----------------------------------------
x2 pieces, both approx 130x150x1.2mm, again both these are double layer 2x2 carbon (these are perfectly flat) £5 each delivered.
-----------------------------------------
x1 peice, approx 065x340x1.2, double layer 2x2 twill £6 delivered.
-----------------------------------------
And I also now have a carbon wrapped ZLET type plug cover, original GM part number is: 55 559 390 VXR

£P.O.A

[Mike]

http://i80.photobucket.com/albums/j181/mikenova/102_1607.jpg

The white specs are just dust from the workshop.

[Mike]

http://i80.photobucket.com/albums/j181/mikenova/102_1614.jpg

[Pistol Pete]

Mike, the ripples...does this mean they are not flat? Need to make a mounting plate/facia for my VX220 dash inside a mk2 cowl.

[Mike]

Pete, ill be honest & say no, there not 100% flat.

It appears during the course of last week whilst I was away, the workshop temperature dropped significantly so the epoxy didnt set properly & stayed wet far to long causing the lot to sag whilst in a vertical position :( hence the ripples :(

There not entirely flat/true, there about 90% there, which unfortunatly means for anyone making model aircraft (70% of my customers) its useless.

Ive been out there today an set up 2 sqm ready to trim tomorrow, hopefully & fingers crossed, they'll be pukka & true. Hopefully...

[Mike]

Up