View Full Version : Nitrous and webbers?
MattBrown
21-01-11, 07:40 PM
Just painted up my 1.0 tank, to use with my pump and reg for my carbs (if I get any)
If I want to run nitrous, am I correct in thinking I'll need a highlressure supply to the injector on the nos nossle? That goes in the inlet?
Or will it run at a 3psi trickle?
Correct. Youll also need to run a direct port kit.
MattBrown
21-01-11, 07:51 PM
Yeah, I did think that mike.
Not sure if it's worth the hassle.
Probably better to get my friend phillip to build me a decent head, and get some cams with the money!
mk1nova_rich
21-01-11, 08:00 PM
Webers FFS lol personally I would put the money into 'permanent' power unless you intend on doing nothing else but drag runs :thumb:
MattBrown
21-01-11, 08:05 PM
Sorry my bad lol
I agree, permo power needed
Or permo power with some gas on top.
MattBrown
21-01-11, 08:17 PM
Be better buying a gripper diff probably.
Apprentice wages suck!
peester
21-01-11, 08:22 PM
both! woohoo..
Gaz'd uses twin carbs and nos on his totb corsa - i think the nos amplifies the roar of the carbs; as well as gainage get both!
I always though he was using TB's Dave?
Not sure if he ran carbs a few years back, but they've definently been running tb's for the past X years.
Yeah I though he was too Adam.
Im basically building an engine to a very similiar spec as his albeit lairyer cams & solid lifters lol
C612DNM
22-01-11, 10:00 PM
there is no substitute for cubic inches! Though a blown 1.8 smallblock would be good. And cost lots.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.