Nitrous and webbers?

[MattBrown]

Just painted up my 1.0 tank, to use with my pump and reg for my carbs (if I get any)


If I want to run nitrous, am I correct in thinking I'll need a highlressure supply to the injector on the nos nossle? That goes in the inlet?

Or will it run at a 3psi trickle?

[Mike]

Correct. Youll also need to run a direct port kit.

[MattBrown]

Yeah, I did think that mike.

Not sure if it's worth the hassle.

Probably better to get my friend phillip to build me a decent head, and get some cams with the money!

[mk1nova_rich]

Webers FFS lol personally I would put the money into 'permanent' power unless you intend on doing nothing else but drag runs :thumb:

[MattBrown]

Sorry my bad lol

I agree, permo power needed

[Mike]

Or permo power with some gas on top.

[MattBrown]

Be better buying a gripper diff probably.

Apprentice wages suck!

[peester]

both! woohoo..
Gaz'd uses twin carbs and nos on his totb corsa - i think the nos amplifies the roar of the carbs; as well as gainage get both!

[Mike]

I always though he was using TB's Dave?

[Adam]

Not sure if he ran carbs a few years back, but they've definently been running tb's for the past X years.

[Mike]

Yeah I though he was too Adam.

Im basically building an engine to a very similiar spec as his albeit lairyer cams & solid lifters lol

[C612DNM]

there is no substitute for cubic inches! Though a blown 1.8 smallblock would be good. And cost lots.