Door poppers and central locking?

[Danb1987]

Abit baffled about this really?

If I buy a universal central locking kit off the bay what else do I need to get the doors to "pop" open? Iv looked at boot pop kits but would I need 3 of them an how do you wire them into a switch under the mirror??

Dan

[brainsnova]

Are you delocking the doors

[Danb1987]

Yeah for the look I'm wanting il be removing handles and locks matey.

Just need some info/advice before I do it.

[brainsnova]

The easiest way if you are using solenoids is to hook up 12v to them and run the earth wire to one side of the switch and the other side of the switch earthed. Or use the earth signal from an alarm to activate them

[Danb1987]

But what are the solenoids I'd need? Just a central locking kit?

Brainsnova do you know where I could get the parts I need from??

[brainsnova]

I'm not 100% what solenoids as some don't have enough travel best way is to buy a single solenoid and try it to see if it works

[Danb1987]

So basicly il need a set of these....
http://i546.photobucket.com/albums/hh431/danpuntosport/CDL4DKITWarehouseWarehouse.jpg

And a couple of these....
http://i546.photobucket.com/albums/hh431/danpuntosport/BhnOi3wmkKGrHqQH-DIEsJrQOheBLJ9TRTCcQ_12.jpg

Wire them in and hope for the best?? lol lol

[brainsnova]

The first ones should do both doors and the boot but you don't need the control module as you are only using them in one direction to lock which will pull the rod from the handle to open the door

[Danb1987]

But would I not need two kits one for the central locking on the alarm fob then just 2 slaves for the door handle mechanism?

Also would I be able to wire to buttons to each door one internal and one external for getting in and out?