matt_vaughan
13-01-11, 10:36 PM
Right, my and my father are looking at getting into small-ish scale fibreglass production. And one thing I've always noticed a lack of is some decent looking arch extensions.
These would basically be a cut and shut type affair to make them as cheap as possible, using minimal materials.
They would not be full wings or rear quarter panels like the ones already available from the likes of Magnum, just a panel which replace the actual arch bulges.
I would be looking at a final product similar to the ones on PickBoy's Corsa A....which can be seen here:
Clicky (http://www.pngclub.com/forum/showthread.php?t=161795)
I will remove link if necessary, just wanted to show the aim of the game.
You're all thinking about price so I will say now we would be looking to bring these in for less than £200 for a full set, and even less if we could manage it.
Just want to gauge interest really as I'm sure a lot of you know its a big investment to produce molds etc etc
These would basically be a cut and shut type affair to make them as cheap as possible, using minimal materials.
They would not be full wings or rear quarter panels like the ones already available from the likes of Magnum, just a panel which replace the actual arch bulges.
I would be looking at a final product similar to the ones on PickBoy's Corsa A....which can be seen here:
Clicky (http://www.pngclub.com/forum/showthread.php?t=161795)
I will remove link if necessary, just wanted to show the aim of the game.
You're all thinking about price so I will say now we would be looking to bring these in for less than £200 for a full set, and even less if we could manage it.
Just want to gauge interest really as I'm sure a lot of you know its a big investment to produce molds etc etc