Settings for solid lifters

[SR-Rally]

Sending head head off to have lifters shimmed up etc but need to no settings. I've been told set inlet to 8thou and outlet to 12thou? It's for a rally car engine with Kent ast19 cam

[thegingerwhinger]

i run mine on 8 thou and 10 thou mate and never had no problems

[SR-Rally]

Cheers :) anyone else?

Someone told me 10thou and 10thou but don't think that's going to be right :s

[thegingerwhinger]

Someone told me 10thou and 10thou :s
thats going to be a noisey fe*ker!! lol

[Gareth_C]

according to the kent manual it says .010" or 0.25mm which ever language you speak. I have the kent book on PDF if you want it

[mk1nova_rich]

according to the kent manual it says .010" or 0.25mm which ever language you speak. I have the kent book on PDF if you want it

please could you send me a copy if I PM you my email address? Cheers

[Gareth_C]

please could you send me a copy if I PM you my email address? Cheers

yeah no bother mate :thumb:

[SR-Rally]

Could you send it to me to please Gareth :) email thats in my sig :)

[philip]

10thou is touch over .25mm. (0.0098'')

but on the xes its 8thou inlet and 10 exhaust. but all the kent site says is .25mm so 10 thou for both