View Full Version : Rose jonited bottom arms
phunkynova
06-01-11, 03:48 PM
Dose any one have any photos of rose jointed bottom arms.
How can they be made ?.
Are they easy to do ? or is it some thing that should not be tried.
Looking at fitting them to a rally car.
Thanks for you input :thumb:
phunkynova
07-01-11, 04:24 PM
some one must know a bit about this one
have a look at harry hockly uniball bottom arms.
Royston
07-01-11, 04:28 PM
I know that Count Vauxalot made some specials for his wide trackday car, look up his thread
craig green
07-01-11, 06:11 PM
Heres the pics I have of mine.
http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/Progress-sale016.jpg
Showing the holes in the lower plates (access to ball joint nuts)
http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/Progress-sale015.jpg
http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/DSCN2138.jpg
http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/DSCN2149.jpg
I cut the bushed end from the std TCA, welded in the TAS supplied threaded block then welded the strengthening plates over the top. The mounting block for the rosejoint is a CNC'd piece of steel with the necessary angles & chamfers on with a suitable (left hand) thread in its end for the Rosejoint. Then there are 2 machined pieces for the Rosejoint to be placed within the mounting point on the car's body.
tom reid
07-01-11, 09:41 PM
How about these?
http://i176.photobucket.com/albums/w195/tomreid/wtsusp4.jpg
http://i176.photobucket.com/albums/w195/tomreid/wtsusp3.jpg
tom reid
07-01-11, 11:02 PM
Ludlow
phunkynova
08-01-11, 02:45 PM
Thanks for you help one this one Craig and Tom :thumb:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.