Rose jonited bottom arms

[phunkynova]

Dose any one have any photos of rose jointed bottom arms.
How can they be made ?.
Are they easy to do ? or is it some thing that should not be tried.
Looking at fitting them to a rally car.
Thanks for you input :thumb:

[phunkynova]

some one must know a bit about this one

[mowgli]

have a look at harry hockly uniball bottom arms.

[Royston]

I know that Count Vauxalot made some specials for his wide trackday car, look up his thread

[craig green]

Heres the pics I have of mine.

http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/Progress-sale016.jpg

Showing the holes in the lower plates (access to ball joint nuts)
http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/Progress-sale015.jpg

http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/DSCN2138.jpg

http://i30.photobucket.com/albums/c323/turbocraig/NovaGSi-WIP_pics/DSCN2149.jpg

I cut the bushed end from the std TCA, welded in the TAS supplied threaded block then welded the strengthening plates over the top. The mounting block for the rosejoint is a CNC'd piece of steel with the necessary angles & chamfers on with a suitable (left hand) thread in its end for the Rosejoint. Then there are 2 machined pieces for the Rosejoint to be placed within the mounting point on the car's body.

[tom reid]

How about these?
http://i176.photobucket.com/albums/w195/tomreid/wtsusp4.jpg
http://i176.photobucket.com/albums/w195/tomreid/wtsusp3.jpg

[Mieran]

^^^ who makes them?

[tom reid]

Ludlow

[phunkynova]

Thanks for you help one this one Craig and Tom :thumb: