View Full Version : underseal
what the best method of removing underseal from the floorpan, wanting my nova painted underneath body colour so was going remove original underseal and start again. also what can i put back on thats over paintable?
cheers
shed-on-wheels
01-01-11, 08:38 PM
i used a little blow tourch dude and put stone chip on and paint over it
i was thinking grinder with wire wheel attachment, was wondering if there is any other methods.
i was going to use the drill lol, im also needing to know what to reapply after that can be painted over? is hammerite a no go?
think it is hammerite mate, dunno how am going paint mine underneath as its burgandy lol
lee-loon
01-01-11, 08:48 PM
Wire wheel would be good,
think it is hammerite mate, dunno how am going paint mine underneath as its burgandy lol
im sure hammerite doesnt mix with normal paint though it reacts
shed-on-wheels
01-01-11, 08:51 PM
hammerite will react dude
ill need to spray mine underneath to maych colour
so basically wire wheel on grinder remove all prime stonechip and paint?
shed-on-wheels
01-01-11, 08:53 PM
i would dude
Twisted knot wire wheel ftw
Etch prime then U-pol Gravitex then paint it is long lasting and the best method IMO
lee-loon
01-01-11, 09:50 PM
Use a proper etch, not a rattle can etch because the rattle can etch primers are crap for large bare metal areas.
I used TFR and a wire wheel for removal.
traffic film remover/tar and glue remover.
I got industrial stuff from a valeter mate, supposed to dilute it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.