Bubba
09-12-10, 09:34 PM
C20XE maifold.
ive decided i refuse to pay for a manifold so im going to make one instead (im such a pikey sometimes) lol and i need a bit of help.
what size is the pipe tube bits that the carbs will connect too?
what angle do they come up from the erm plate bit?
i can get the bit they go into water cut from and size steel plate but i need to know what angle they slot into it at, pics of a side on view might help
infact pics of just the manifold from various angles would be appreciated
+rep for helpings :)
ive decided i refuse to pay for a manifold so im going to make one instead (im such a pikey sometimes) lol and i need a bit of help.
what size is the pipe tube bits that the carbs will connect too?
what angle do they come up from the erm plate bit?
i can get the bit they go into water cut from and size steel plate but i need to know what angle they slot into it at, pics of a side on view might help
infact pics of just the manifold from various angles would be appreciated
+rep for helpings :)