View Full Version : 1.2 loom
20-martyn-09
18-11-10, 10:26 AM
i have taken all wires of my 1.2 engine but where the ecu is 3 wires runing back into dash do i just cut these to get the loom out ? so i can start to put my c20ne loom in. or trace back ??
20-martyn-09
18-11-10, 11:19 AM
k reg , nova swing
20-martyn-09
18-11-10, 11:29 AM
yes think so !
ok, take the glovebox out, get the ecu, cut all the wires off both plugs and pull the wires out into the bay. you will have 4-5 clock feed wires and a few perms. you can tape the perms up as they arnt needed. then use the sensor ones on the corrresponding colours on the new engine loom.
tommy8252
18-11-10, 06:55 PM
yeah as rob said dont cut the wires from the bay side as youll be left with a big mess and headache (I know as this is what I did for my e16se conversion)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.