1.2 loom

[20-martyn-09]

i have taken all wires of my 1.2 engine but where the ecu is 3 wires runing back into dash do i just cut these to get the loom out ? so i can start to put my c20ne loom in. or trace back ??

[Sloth]

what 1.2 is it?

[20-martyn-09]

k reg , nova swing

[Sloth]

so its spi?

[20-martyn-09]

yes think so !

[Sloth]

ok, take the glovebox out, get the ecu, cut all the wires off both plugs and pull the wires out into the bay. you will have 4-5 clock feed wires and a few perms. you can tape the perms up as they arnt needed. then use the sensor ones on the corrresponding colours on the new engine loom.

[tommy8252]

yeah as rob said dont cut the wires from the bay side as youll be left with a big mess and headache (I know as this is what I did for my e16se conversion)