arches

[shanehandley]

i no this as been asked before but cnt find it in the posts!

i got new alloys on way and want to grind arches i got angle grinder so do u just grind them then seal them to stop them from rusting.

can u cut the lip in every 5 inche intervials etc and nock it up with and hammer :| ?

i hope u no wot i mean :o any help would be good :lol:

shane

[mmollart]

if your going to get the grinder on them, dont go past the spotwelds on the lip

[Will]

lol@spot welds, they prob rotted away neway, its such an old car its not gona be strong in a crash, have fun with the grinder, me and breeny did in the summer

[locky]

Be aware of the fuel!!!!!
I h8 grinding, iv spend hrs n hrs grinding in work!!!!!
(only if i was a pornstar then grinding would b fun..........)

[shanehandley]

i had a look at the lips and on the back there only bout a cm wide and on front even less is this ok!

this is with out me grindin them

[mikeoxford]

dont even bother polaying with nova arches

get it sorted propley

there p@nts

:evil: