View Full Version : GSI ENGINE
thesparky
23-05-03, 11:57 AM
dun more checks(GSI ENGINE PROBS AGAIN) and find the oil pres is looking high nearly full on gauge but at tic over drops to the first line on gauge also after a long run it needed quite alot of water M8 said it could be a head gasket prob? :(
yup, either water leak of gasket, and those oil guages r not very accurate, just do a good job of telling u when its empty :)
mikeoxford
23-05-03, 11:12 PM
headgasket is easy enough if you have the tools
Snowface
23-05-03, 11:14 PM
the hardest part is trying to undo the rusty bolts on the exhaust manifold. Thats what i found neway.
the oil pressure sender units always fuck up but that has to be a blown head gasket if yer losin water. is the oil gettin gunky under the cap?
thesparky
24-05-03, 03:41 PM
no the oil is clean ?
thesparky
24-05-03, 04:44 PM
checked oil pres it is 65psi at tickover rising to 70 psi when reved dose anybody know if this is correct
oil pressure is unreliable anyway unless youre absolutely 100% you have the correct level of oil in i.e. overfilling will result in high pressure
thesparky
24-05-03, 04:55 PM
i just thought it was high cus the tis says 1.5 (22psi) bar at tick over
mikeoxford
26-05-03, 10:41 PM
i just thought it was high cus the tis says 1.5 (22psi) bar at tick over
:? 1.5 is a diesil
thesparky
26-05-03, 10:51 PM
1.5bar pressure
mikeoxford
26-05-03, 11:34 PM
1.5bar pressure
:oops: apologies
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.