PDA

View Full Version : Are these 1300 pistons low comp ?



Edd
01-10-10, 01:50 PM
Started stripping down my 1300 turbo engine today,

As the only set of standard pistons are in the built up engine in the car I cannot compare them,

So are these low comp ones ?? I think they look different to standard but not sure

Pics;

http://i499.photobucket.com/albums/rr359/EDDRODGERS/0cacea0f.jpg

http://i499.photobucket.com/albums/rr359/EDDRODGERS/a0197dd0.jpg

And some writing;

http://i499.photobucket.com/albums/rr359/EDDRODGERS/8700980e.jpg

Edd

AlexW
01-10-10, 02:01 PM
I cant remember what std 8v pistons look like but they could be. Deffo oversized (.5mm).

mowgli
01-10-10, 02:03 PM
definitely low comp. +20thou (in old money) oversize.

look on this link.. (http://www.ms-motor-service.com/ximages/PDF_Kataloge/ko_opel_web.pdf)it looks a lot like item 8, the normal one is item 9

garyc
01-10-10, 02:06 PM
they look like it to me, as the 1300 ones have round cut outs for the valves. Yours look like the whole dish is as deep as the std cut outs.

Edd
01-10-10, 02:23 PM
:d happy days

Am I going to have difficulty getting new rings for them tho ?

mowgli
01-10-10, 02:33 PM
no, oversize rings for any gm 1300 should do. it all depends how worn the bores are really..

if you want to get really old school, buy .75 rings & then use a small file to gap them properly. it takes ages but it works. i can't remember how many thou (40 to the mm) gap per inch of bore it is, but mr internet will tell you

Royston
01-10-10, 03:33 PM
Not the best pic, but the only one I have to hand, 0.5mm oversize and valve cutouts enlarged to suit my big valves

http://img.photobucket.com/albums/v697/1297cc/DSCF1995.jpg

Mine are std compression, the std valve cutouts were in the piston crown, so suspect yours are low comp

Royston
01-10-10, 04:00 PM
Don't know if this may help
http://img.photobucket.com/albums/v697/1297cc/DSCF1701-2.jpg

General Baxter
01-10-10, 06:58 PM
they do look slightly special :p

craig green
01-10-10, 07:13 PM
BINGO Ted!

mowgli
01-10-10, 07:23 PM
they do look slightly special :p

they weren't special at all.. just a low compression 1300 as fitted in opel kadetts to give 55hp and run on 2 star fuel.

Andy
01-10-10, 07:25 PM
ooh they most certainly look to be.Andy likes alot

Andy
01-10-10, 07:26 PM
they weren't special at all.. just a low compression 1300 as fitted in opel kadetts to give 55hp and run on 2 star fuel.
is that where theyre from? You learn summat every day:thumb:

mowgli
01-10-10, 08:05 PM
if you lot bothered to look at my linky on page 1 you'd learn loads...oe spec piston catalogues are fascinating for engine conversions....

i bought my previous nova as a '1200', and found it actually had a low comp 1.3.. i weighed it in...

my 1200+1300=1400 conversion was also based on a 1.3 lo comp from a kadett.