PDA

View Full Version : 1300 nova not cranking



Rickyb
24-09-10, 08:45 PM
hi all just finished fitting my 13s engine to my nova it had a 1200 carb engine in before.
anywho i wired it all up like the 1200 was but the bloody thing wont crank over the only thing i can think of is on the astra loom theres a thick black wire in the same loom as the red+black one anyone any idea what i need or might have done wrong??
rick

stevie78
24-09-10, 08:47 PM
bad earth ?

Sloth
24-09-10, 08:57 PM
eatrhs? all you need is a perm live to the starter, an earth ont block and a switched off the starter.

Rickyb
24-09-10, 08:57 PM
yeah maybe im gonna try adding a few new earths tomorow.
the black plus red is switched??

Andy
24-09-10, 09:18 PM
yes,you really cant go wrong to be honest

Rickyb
24-09-10, 09:25 PM
aye i was a bit stresed before so i gave up pretty quick but to be fair i have been busy since 7 this morning.

mowgli
24-09-10, 09:39 PM
every wire should go on in the same place. even the old 1200 starter will fit. it is a straight swap. did you swap the gearbox too?

AlexW
24-09-10, 09:40 PM
Just to see if its a earth put a jump lead from a hoist point on the engine and onto teh neg side of the batt

buzbi
24-09-10, 09:45 PM
1, check you have clean earth from engine to chassis (shell)
2, check that you got power to big terminal on starter
3, check that you have power down signal wire to solinoid when key turned to start (little wire)

if you are unsure you can always bridge across from the main power supply nut on the starter direct to the signal terminal on the solinoid using a bit of wire/old spanner etc.

if it cranks this would prove that you have power to the starter and a ok earth back and that you need to find why you have no feed to the solinoid

Rickyb
25-09-10, 11:19 AM
i took the 1300 engine out of my mk1 astra estate which was auto, changed the flywheel (need to buy a clutch) and put a f10/5 on it ploped it in the bay and built it back up and wen i tryed starting it it just clicked like the battary was dead so changed the battary and no clicking or awt i knocked the starter still nothing put a wire from the signal/switched wire and touched it on the live side of the battary and still nothing so im thinking it can only be down to bad earth so il try that first today then il go threw all the other things you's have put up.
thank you all very much for your reply's its most appreciated (sp)
rick

Rickyb
25-09-10, 11:35 AM
oh and i didnt have any bits of the 1200 left that went ages ago :( fingers crossed its just an earth.

Rickyb
25-09-10, 05:45 PM
thanks for al the advice people it was the main earth strap from the chassie to the box it wasnt tight enuf lol so thats it sorted :D il rep all who i can.